User's Manual

ServerȱandȱSensorȱOverviewȱ
SpectraGuard
®
ȱEnterpriseȱInstallationȱGuideȱ
9ȱ
Table 6. Rear Panel Port Settings for SS-200-AT
Port Description Connector Type Speed/Protocol
Serial
Enables a serial connection to
establish terminal sessions;
used for launching Config Shell
sessions
DB-9
Settings:
Bits per second: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Protocol: RS-232
Ethernet
Enables the device to be
connected to the wired LAN
through a switch or a hub. This
connection allows the Sensor to
communicate with the Server
RJ-45
Settings:
10/100 Mbps
Protocol:
Ethernet
ȱ
Note:ȱTheȱSpeed/ProtocolȱsettingsȱmentionedȱinȱtheȱaboveȱtableȱareȱtheȱsameȱforȱHypeȱTerminalȱandȱminicom.ȱ
3.5 RearȱandȱSideȱPanelsȱofȱSensorȱSSȬ300ȬATȱ
TheȱrearȱpanelȱofȱtheȱSensorȱSSȬ300ȬATȱhasȱanȱEthernetȱportȱthatȱenablesȱtheȱdeviceȱtoȱbeȱconnectedȱtoȱtheȱwiredȱLANȱthroughȱ
aȱswitchȱorȱaȱhubȱandȱalsoȱprovidesȱtheȱpowerȱforȱtheȱdeviceȱusingȱ802.3afȱstandard.ȱȱ
ȱ
Figure 8. Rear Panel of Sensor SS-300-AT
TheȱSensorȱhasȱtheȱfollowingȱports:ȱ
x Ethernetȱport:ȱConnectsȱtheȱSensorȱtoȱtheȱnetworkȱandȱalsoȱprovidesȱtheȱpower.ȱ
Table 7. Rear Panel Port Settings for SS-300-AT
Port Description Connector Type Speed/Protocol
Ethernet
This enables the device to be
connected to the wired LAN
through a switch or a hub. This
connection allows the
SpectraGuard Sensor to
communicate with the
SpectraGuard Enterprise®
Server.
This port also provides the
power for the device using
802.3af standard
RJ-45
10/100/1000 Mbps
Ethernet
Power over Ethernet
ȱ
Note:ȱTheȱSpeed/ProtocolȱsettingsȱmentionedȱinȱtheȱaboveȱtableȱareȱtheȱsameȱforȱHypeȱTerminalȱandȱminicom.ȱ