User's Manual
SS‐300‐AT‐C‐60InstallationGuide
1
7
Chapter6 SS‐300‐AT‐C‐60ConfigShellCommands
ThefollowingtablesdetailtheSS‐300‐AT‐C‐60configshellcommands.
Table1.getcommands
get Commands
Command Description
get ap Displays all the currently visible APs
get interface Displays Network Interface speed and mode
get ip config
(deprecated)
Displays the IP information
get log Displays the log information as it is created
get log config Displays the configuration of the logger
get mode Displays the mode in which the Sensor is currently configured
get rf Displays if RF monitoring for a Sensor is ‘ON’ or ‘OFF’
get serial num Displays the Board Number
get server discovery Displays the Server discovery/setting information
get status Displays the current running status of all the components
get version Displays the version and build information of all the components
get vlan config Displays listing of VLANs which are configured for monitoring by ND or Sensor
get vlan id Displays listing of all VLANs which can be detected by ND or Sensor
get vlan status Displays status of VLANs which are configured for monitoring by ND or Sensor
get model Displays the Sensor Model
get antenna Displays antenna configuration (Internal/ External)
Table2.setcommands
set Commands
Command Description
set erase Sets the erase character to ^H.
set interface Sets Network Interface properties like auto negotiation, speed, and duplex settings.
set ip config Runs through the current VLAN and IP config wizard.
set server discovery Sets the Server discovery information.