User's Manual


SS‐300‐AT‐C‐60InstallationGuide

• SensorMode:Thisisthedefaultmode.Inthismode,thedeviceshouldbeconnectedintoatrunkport(802.1Q
capable)onaswitch.ItthenmonitorsmultipleVLANsthatareconfiguredonthattrunkportandarechosenbythe
userusingtheNDCLI.Thewirelessinterfaceof
theSensorisenabled.Similarly,anSS‐300‐AT‐C‐60canmonitorupto
16VLANs.
• NDMode:Thismodeneedstobeexplicitlyconfigured.Inthismode,thedeviceshouldbeconnectedintoatrunk
port(802.1Qcapable)onaswitch.ItthenmonitorsmultipleVLANsthatare
configuredonthattrunkportandare
chosenbytheuserusingtheNDCLI.ThewirelessinterfaceoftheNDisdisabled.ASS‐300‐AT‐C‐60functioningasa
WIPSsensorcandetectandmonitorupto100VLANs.
• Usethesetmodecommandtosetthedevice
modeforSS‐300‐AT‐C‐60.


Figure 19. set sensor mode command for SS-300-AT-C-60
5.2.5 ConfigureNetworkSettings
Oncethemodeisset,youhavetoenabletheNetworkSettings.
NetworkDetector/SensorMode:Forthismode,usethecommandsetvlanconfig.ThiscommandconfigurestheIPaddresses
ontheND.
RefertoChapter3:GuidelinesforConfiguringandInstallingNDinthedocument‘NetworkDetectorConfigurationfor
SpectraGuardEnterprise_6.7Update1’forfurtherdetails.
5.2.5. 1 ConfigureIPv6se ttin gs
SS‐300‐AT‐C‐60isIPv6capable.Usethecommandsetipv6configtoconfigureadvancedoptionssuchasDHCPsettings,auto
negotiationandmanualconfiguration.
Note:IPv6settingsarenotsupportedintheSS‐200‐ATsensorsHowtoconfigureCommunicationkeyorPassphrase 
5.2.5. 2 HowtoconfigureCommunicationKe yorPassphrase
ToconfigurethecommunicationkeyorpassphrasekindlyrefertoAppendixA:MutualAuthenticationfordetails.
