User's Manual


SS‐300‐AT‐C‐60InstallationGuide
Figure 17. Edit Serial Port Settings for Sensor SS-300-AT-C-60
• Edittheserialportsettingsasfollowsorclick<RestoreDefaults>toensurepropercommunicationbetweenthe
Sensorandyourcomputer.
 Bitspersecond:115200

Databits:8

Parity:None

Stop

bits
:1

Flowcontrol:None
• Click<OK>ontheCOMPropertiesdialog.

Press<Enter>or<Space>ontheHyperTerminalscreen.
5.2.2 LoginandChangetheDefaultPassword
LogintotheConfigShellusingtheusernameconfigandpasswordconfig.Changethedefaultpasswordusingthecommand
passwd
.YoucanchangetheSensorpasswordusingSensortemplates.Refertosection8.4.4:SensorConfigurationinthe
SpectraguardEnterpriseUserGuideformoredetails.
Recommended;AirTightrecommendsthat
youchangethedefaultpasswordforsecurityreasons,althoughitisnotmandatory.
5.2.3 SetServerDiscovery
ThenextstepistosettheServerDiscoveryinformation.TherearetwotypesofServerDiscovery.
• ServerIPbaseddiscovery(preferred)
• ServerIDbaseddiscovery(deprecated)
ServiceLocationProtocol(SLP)baseddiscovery(ifwifi‐security‐serverservicehasbeenconfigured)
Usethecommandsetserverdiscoverytopointthe
SensortothecorrectServer.

Figure 18. set server discovery command
Note:IfIP/Hostnamebaseddiscoveryisbeingusedandthereis morethanoneServeronthenetwork,thenyoumustentertheIPaddress
oftheappropriateServer .
5.2.4 SetSensorMode
ThenextstepistosetthemodeoftheSensor.Therearetwopossiblemodes: