User's Manual


SS‐300‐AT‐C‐60InstallationGuide

1. Attachthemetalslidertothebackofthedeviceusingthetwosmallscrews.Theslidershouldstillbeabletoslideafter
thescrewsaretightened.

Figure 5. Attaching the Metal Slider
Makesurethattheslideisleftinthesamepositionasshownabove.
Clipthemetalceilingbrackettoasuitably‐locatedceilingtileseparator.

Figure 6. Clipping the Metal Ceiling-bracket
Slidethemovablesectionintoplaceandtightenthescrew(foundunderneath)tosecureit

Figure 7. Sliding the movable section
Positionthedevicesuchthatthetwotabsfromtheceilingbracketlocateintheslotsinthedevice(A),thenslidetheslider
acrosstolockthedevicetothebracket(B). 