User's Manual


SS‐300‐AT‐C‐60InstallationGuide
Solid Orange Any Any Slow Blink The AP is unable to connect to the Server.
Off Off Off Off
The AP is not powered on or it is in the process of
starting up.
WLAN2LEDwillblinkwhenthereisactivityontheAPradio.

Note:Ifnochannelsarespecifiedformonitoringandpreventiononthesensorradio,therespectiveLEDwillhave noactivityanditwill
notglow.
TherearpaneloftheSS‐300‐AT‐C‐60hastwoEthernetports‐LAN1andLAN2,thatenablesthedevicetobeconnectedtothe
wiredLANthroughaswitchorahubandprovidesthepowerforthedeviceusing802.3afstandard.

Figure 3. Rear Panel of SS-300-AT-C-60
Table 4. Rear Panel Port Settings for SS-300-AT-C-60
Port Description
Connector
Type
Speed/Protocol
Ethernet
(LAN1)
This enables the device to be connected to
the wired LAN through a switch or a hub.
This connection allows the SpectraGuard
Sensor to communicate with the
SpectraGuard Enterprise® Server.
This port also provides the power for the
device using 802.3af standard
RJ-45
10/100/1000 Mbps Ethernet
Power over Ethernet
Ethernet
(LAN2)
This enables the device to be connected to
the wired LAN through a switch or a hub.
This connection allows the SpectraGuard
Sensor to communicate with the
SpectraGuard Enterprise® Server.
This port also provides the power for the
device using 802.3af standard
RJ-45
10/100/1000 Mbps Ethernet
Power over Ethernet
