User's Manual


SS‐300‐AT‐C‐60InstallationGuide

Table 2. LED details for SS-300-AT-C-60 in sensor mode
LED1 or

Power
LED2 or

WLAN1
LED3 or

WLAN2
LED4 or

LAN
Description
Solid Green Solid Green Solid Green Solid Green
The Sensor is receiving power and is working
normally. The Sensor is connected to the
Server.
Solid Green Solid Green Fast Blink Solid Green
The Sensor is performing troubleshooting on
802.11a/n.
Solid Green

Solid Green

Slow Blink

Solid Green

The Sensor is performing intrusion prevention
on 802.11a/n.

Solid Green Fast Blink Solid Green Solid Green
The Sensor is performing troubleshooting on
802.11b/g/n.

Solid Green Fast Blink Fast Blink Solid Green
The Sensor is performing troubleshooting on
802.11b/g/n and 802.11a/n.

Solid Green Fast Blink Slow Blink Solid Green
The Sensor is performing troubleshooting on
802.11b/g/n and intrusion prevention on
802.11a/n.

Solid Green

Slow Blink

Solid Green

Solid Green

The Sensor is performing intrusion prevention
on 802.11b/g/n.

Solid Green Slow Blink Fast Blink Solid Green
The Sensor is performing intrusion prevention
on 802.11b/g/n and troubleshooting on
802.11a/n.

Solid Green

Slow Blink

Slow Blink

Solid Green

The Sensor is performing intrusion prevention
on 802.11b/g/n and 802.11a/n.

Solid Green Off Slow Blink Slow Blink The Sensor upgrade is in progress.
Solid Orange Any Any Solid Green The Sensor is unable to get Ethernet link.
Solid Orange Any Any Fast Blink
The Sensor did not receive a valid IP address
via the DHCP.
Solid Orange Any Any Slow Blink The Sensor is unable to connect to the Server.
Solid Orange Solid Green Any Any There is an error on 802.11a/b/g/n interfaces.
Solid Orange

Any

Solid Green

Any

The Sensor is experiencing a software error.

Off

Off

Off

Off

The Sensor is not powered on or it is in the
process of starting up.


ThefollowingtableindicatesvariousdevicestatesusingtheLEDsonthedevice,whenthedeviceisinAP/sensorcombomode,
thatisoneradioisconfiguredtofunctionasanAPandtheotherradioisconfiguredtofunctionasasensor.
Table 3. LED details for SS-300-AT-C-60 in AP/sensor combo mode
LED1 or
Power
LED2 or
WLAN1
LED3 or
WLAN2
LED4 or
LAN
Description
Solid Green Solid Green Any Solid Green
The AP-Sensor is receiving power and is working
normally. The AP-Sensor is connected to the
Server.
Solid Green Fast Blink Any Solid Green
The Sensor is performing Troubleshooting on
802.11a/b/g/n
Solid Green Slow Blink Any Solid Green
The Sensor is performing Prevention on
802.11a/b/g/n
Solid Green Off Slow Blink Slow Blink The AP upgrade is in progress.
Solid Orange Any Any Solid Green The AP is unable to get Ethernet link.
Solid Orange Any Any Fast Blink
The AP did not receive a valid IP address via the
DHCP.