User's Manual

Manual Configuration of SpectraGuard Sensor
SpectraGuard Sensor Installation Guide
27
Figure 23 Resetting to factory default settings using the resetfactory command
Viewing the status of SpectraGuard Sensor
statusóThis command shows the current status of the Sensor. The two possible states are "Not
Running" or "Running".
Figure 24 status command
Viewing the status of the SpectraGuard Sensor software
veróThis command displays the version of the software running on the Sensor.
Figure 25 ver command
Getting the host information
pingóThis command invokes the common "ping" program which checks whether a host is
reachable or not. It exits after sending and receiving four packets.
Important! Don't use Control + C, as it causes the shell to exit.
Figure 26 ping command
Restarting the Sensor
sensord_restartóThis command restarts the Sensor i.e. causes the SpectraGuard Sensor software to
reinitialize. You do not need to reconfigure Sensor after the restart.