User's Manual

Manual Configuration of SpectraGuard Sensor
SpectraGuard Sensor Installation Guide
22
Note: If IP address assignment via DHCP fails, the default values assigned are as follows:
IP address = 192.168.3.58
Net Mask = 255.255.255.0
If DHCP fails, the Sensor software doesn't begin execution.
The following screen is an example from a live session.
Figure 18 Changing network settings using the setdhcpip command
setstaticip
This command allows you to assign a static IP address for the Sensor and prompts you for the
following inputs:
 A valid IP addressóThe IP address should be compatible with the network segment on which
this SpectraGuard Sensor is to be connected.
 The corresponding subnet maskóThis represents the mask of the network segment to which
the SpectraGuard Sensor will be connected.
$ setdhcpip
Stopping SpectraGuard Sensor...
Getting IP over dhcp...
Enter Route Settings or press Enter to skip settings routes
Route Settings:
Network ID:
Applying Changes...
Ethernet MAC Address = 00:11:74:20:10:C4
Boot IP Protocol = dhcp
IP=192.168.3.58 Mask=255.255.255.0 Gateway=