C-130 Mojo Access Point Quick Start Guide Package Contents The C-130 package must contain the following components.
Mounting the C-130 1. Affix bracket to T - Grid. 3. Place the first mounting post on the rear-side of the device on to the lower notch of the bracket. 2. Rotate bracket to snap on to T- Grid. 4. Rotate the device such that the center mounting post fits in to the center notch on the bracket. 5. Ensure that all the mounting posts on the rear-side of the device are snapped in to the respective notches on the bracket.
Getting the C-130 Online Step 1: Power Up the Device Plug one end of an Ethernet cable into the PoE+ (802.3at) switch or injector and the other end into the Ethernet/PoE+ port on the C-130. Ensure the PoE+ source you are using is turned ON. Note: You can also use regular PoE (802.3af). However it will disable some features. To know more refer to C-130 Installation Guide.
Troubleshooting After the C-130 is connected to the network and powered ON, if the LED for Power/Ethernet is not Solid Green, the AP has encountered a problem or is in the upgrade process. The following guidelines may help you to quickly diagnose and fix the problem. LED Status Power/ Ethernet Wi-Fi 2.
