User's Manual

Getting the C-120 Online
Step 1: Power up
If using PoE, plug one end of the Ethernet cable into the PoE switch or injector and
plug the other end into the Ethernet + PoE port (LAN1) on the C120. Make sure the PoE
source you are using is turned ON.
OR
As an alternative to PoE, insert the power adapter plug into an AC power outlet and the
other end into the power input port on the C120.
Warning: If not using PoE, make sure you use only an AC power adapter supported by
the C120 access point (AP).
Step 2: Connect to the network
If you are using PoE, then the C120 should already be connected to your network. If you
are not using PoE, then plug one end of the Ethernet cable into an Ethernet jack on your
network and the other end into the Ethernet port (LAN1) on the C120.
Step 3: Check the LED status
Wait for a few minutes till the
LEDs for Power and Ethernet (LAN1)
turn solid GREEN, which indicates that
the C120 is online and operational.