User's Guide

AirTight Management Console Configuration
81
Field Description
Remote Endpoint(IP
Address)
The IP address of the primary remote server or endpoint. It can
be left blank, if you want to use NTP server IP (from DHCP
option 42) as the remote endpoint.
Local Endpoint VLAN
The VLAN ID through which AP will form tunnel to the remote
endpoint. A value between 0 and 4094 should be entered here.
Remote Endpoint must be reachable through this vlanVLAN.
Secondary Endpoint Related Parameters
Enable Secondary
Endpoint
Secondary endpoint is remote endpoint to which the wireless
traffic is diverted if the primary endpoint goes down.
Select this check box if you want to enable a secondary
endpoint.
Remote
Endpoint(IP Address)
The IP address of the secondary remote server or endpoint. It
can be left blank, if you want to use NTP server IP (from DHCP
option 42) as the remote endpoint.
Local Endpoint VLAN
The secondary VLAN ID through which the wireless network
traffic is to be routed. A value between 0 and 4094 should be
entered here. Remote Endpoint must be reachable through this
VLAN.
Network Probe
Interval
The interval, in seconds, after which the AP checks
connectivity with remote endpoint by sending a ping request
packet. This can have a value between 10 and 3600. The
interval must be a multiple of 10.
Network Ping Retry
Count
Count of ping request packets that the AP sends to the remote
endpoint.
Network Ping Timeout Time, in seconds, till which the AP waits for a ping reply.
Prefer Primary Tunnel
over Secondary
Tunnel
Select the check box if you want the AP to check for the
availability of the primary tunnel. If the check box is not
selected and the primary tunnel is down, the AP continues to
operate on the secondary tunnel.
Ethernet over GRE
GRE Primary Key
Key in the primary endpoint GRE header. If configured, key
should be same at both ends of the tunnel. Key is not
mandatory to be configured in GRE tunnel
GRE Secondary Key
Key in the secondary endpoint GRE header. If configured, key
should be same at both ends of the tunnel. Key is not
mandatory to be configured in GRE tunnel
3. Click Save to save the changes.
Change Location for Network Interface Profile
To move the network interface profile to another location, do the following.
1. Go to Configuration>Device Configuration>Network Interfaces.
2. Select the location at which the network interface profile has been defined.
3. Select the check box for the network interface that you want to move to another location.
4. Click the change location icon. The Select Location dialog box appears.
5. Select the new location and click OK. The network interface is moved to the new location.