User's Guide

AirTight Management Console User Guide
80
Field Description
Remote
Endpoint(IP
Address)
The IP address of the primary remote server or endpoint. It can be left
blank, if you want to use NTP server IP (from DHCP option 42) as the
remote endpoint.
Local
Endpoint
VLAN
The VLAN ID through which AP will form tunnel to the remote endpoint. .
A value between 0 and 4094 should be entered here. Remote Endpoint
must be reachable through this VLAN.
Secondary Endpoint Related Parameters
Enable
Secondary
Endpoint
Secondary endpoint is remote endpoint to which the wireless traffic is
diverted if the primary endpoint goes down.
Select this check box if you want to enable a secondary endpoint.
Remote
Endpoint(IP
Address)
The IP address of the secondary remote server or endpoint. It can be left
blank, if you want to use NTP server IP (from DHCP option 42) as the
remote endpoint.
Local
Endpoint
VLAN
The secondary VLAN ID through which the wireless network traffic is to be
routed. A value between 0 and 4094 should be entered here. Remote
Endpoint must be reachable through this VLAN.
Network
Probe
Interval
The interval, in seconds, after which the AP checks connectivity with
remote endpoint by sending a ping request packet. This can have a value
between 10 and 3600. The interval must be a multiple of 10.
Network
Ping Retry
Count
Count of ping request packets that the AP sends to the remote
endpoint. The default value is 3.
Network
Ping
Timeout
Time, in seconds, till which the AP waits for a ping reply. The default value
is 60 seconds.
Prefer
Primary
Tunnel
over
Secondary
Tunnel
Select the check box if you want the AP to check for the availability of the
primary tunnel. If the check box is not selected and the primary tunnel is
down, the AP continues to operate on the secondary tunnel.
Ethernet over GRE
GRE
Primary
Key
Key in the primary endpoint GRE header. If configured, key should be
same at both ends of the tunnel. Key is not mandatory to be configured in
GRE tunnel
GRE
Secondary
Key
Key in the secondary endpoint GRE header. If configured, key should be
same at both ends of the tunnel. Key is not mandatory to be configured in
GRE tunnel
3. Click Save to save the network interface profile.
Edit Network Interface Profile
To edit a network interface profile, do the following.
1. Go to Configuration>Device Configuration>Network Interfaces.
2. Make the necessary changes.
Field Description
Profile Name
Name of the network interface profile. It can have a maximum
length of 260 bytes.
Tunnel Type Select Tunnel Type as Ethernet over GRE.
Basic Parameters (or Primary Endpoint Parameters)