User's Guide

AirTight Management Console User Guide
184
IP Address
IP address of the client.
Vendor
Name of the Client manufacturer. The vendor name is inferred from
the first three bytes of the MAC address.
Protocol
802.11 protocol in which the client is currently operating.
Channel
Channel number that the client operates on.
Security
Security standard applied to the AP. This is derived from the
template applied to the AP.
Network
Additional information about the IP Address and subnet that
identifies the network on which the Client is located.
Associated to AP
BSSID of the AP that the client is associated with.
First Detected at
Date and time when the client was first detected by the system.
Quarantine Status
Indicates if the client is in quarantine.
Defending Sensor
Name
Name of the defending sensor.
Quarantine
Pending Reason
Specifies the reason if quarantine is pending.
Bridging/ICS Mode
Indicates if the client is in bridging/ICS mode. 'Yes' indicates that
the client is in bridging/ICS mode.
'No' indicates that the client is not in bridging/ICS mode.
Running Soft AP?
Indicates if a soft AP is running on the client.
'Yes' indicates that a soft AP is running on the client.
'No' indicates that a soft AP is not running on the client.
WDS Mode
Indicates if Wireless Distribution System (WDS) is enabled. This is
applicable only if the client is an AP, and has connected to a WDS
AP.
Tx STBC 802.11n
Indicates support for transmission of PPDUs using STBC for active.
'Yes' indicates that transmission of PPDUs using STBC is
supported for active 802.11n client.
'No' indicates that transmission of PPDUs using STBC is not
supported for active 802.11n client. This field is visible for active
802.11n clients only.
Rx STBC 802.11n
Indicates support for reception of PPDUs using STBC for active
802.11n client.
If this reception is supported, the number of spatial streams
supported are indicated. Upto 3 spatial streams are supported for
the 802.11n protocol.
If this reception is not supported, the value of this field is 'Not
supported'.
This field is visible for active 802.11n clients only.
802.11ac Capability
This field is visible for active 802.11ac clients only. It indicates if
the client has built-in support for 802.11ac protocol.
'Yes' indicates that the client is 802.11ac capable.
Tx STBC 802.11ac
Indicates support for transmission of PPDUs using STBC for the
active 802.11ac client.
'Yes' indicates that transmission of PPDUs using STBC is
supported for the active 802.11ac client.
'No' indicates that transmission of PPDUs using STBC is not
supported for the active 802.11ac client.
This field is visible for active 802.11ac clients only.
Rx STBC 802.11ac
Indicates support for reception of PPDUs using STBC for active
802.11ac client.