User's Guide

AirTight Management Console User Guide
102
6.
Specify the following for nodes imported with AirTight Planner-
Minimum Signal Decay Constant,
Maximum Signal Decay Constant, signal decay slope(beta), signal decay slope(alpha).
7.
Specify the following for nodes with GIF, JPEG or blank layout- Minimum Signal Decay Constant,
Maximum Signal Decay Constant, signal decay slope(beta), signal decay slope(alpha).
8.
Click Save to save the changes.
Restore RF Propagation Defaults
You can restore the RF propagation fields to their default values. The default values for the RF
propagation related fields are as mentioned in the following table.
Sensor Antenna Gain 2.3 db
AP Antenna Gain 2.3 db
Client Antenna Gain 0 db
Loss at Source for 802.11a Transmitter 10 db
Loss at Source for 802.11b/g Transmitter 10 db
For Nodes imported with AirTight Planner
Minimum Signal Decay Constant 2
Maximum Signal Decay Constant 2
Signal Decay Slope(Beta) 0.08
Signal Decay Slope(Alpha) -4
For Nodes with GIF, JPEG or blank layout
Minimum Signal Decay Constant 2
Maximum Signal Decay Constant 2.5
Signal Decay Slope(Beta) 0.08
Signal Decay Slope(Alpha) -4
To restore RF propagation settings, do the following.
1.
Go to Configuration>System Settings>Advanced Settings>RF Propagation.
2. Click Restore Defaults. The fields are populated with their default values.
3. Click Save to save the changes.
Copy RF Propagation Setting to Another Server
You can copy the RF propagation settings from one server to another server when both servers are part
of the same server cluster. You can copy RF propagation settings from child server to child server, parent
server to child server, or child server to parent server. You must be a superuser or an administrator to
copy policies from one server to another.
To copy RF propagation settings settings, do the following.
1.
Go to Configuration>System Settings>Advanced Settings>RF Propagation Setting on the
parent server.
2.
Click Copy Policy. The Copy Policies dialog box appears.
3. Select the server from which the RF propagation settings is to be copied.
4. Select the server to which the RF propagation settings is to be copied.
5. Click OK to copy the RF propagation settings.