Assembly & Operation Instructions

MoJack 750XT Lift

Operating Instructions

STEP 7

STEP 8

Reverse Front Tires of Mower (optional – if not applicable, skip to Step 9)

• In some cases, the mower deck or anti-scalping wheels will hit the

Lift Arm while the mower is being raised. This is often the case if

part of the deck (including the anti-scalping wheels) protrudes past

the center line of the front wheels of the mower.

• Rotate the front tires 180° so that they are in the reverse position.

• Remove the Support Rods from the Wheel Pads and slide the

MoJack 750XT underneath the mower.

• Secure the Support Rods to Wheel Pads with Large Hair Pins.

Adjusting Support Rods for Proper Tire Size

• Adjust Support Rods on Wheel Pads to accommodate the

front tire size of the mower. Please refer to the chart below

for proper Support Rod placement based on the diameter

of the mower’s front tires.

• Secure Support Rods to Wheel Pads with Large Hair Pins.

Reverse

Wheel

Position

Forward

Wheel

Position

Support Rod

Large Hair Pin

See page 20 for more more detailed guide.

10” - 11.5” (25cm - 29cm)

12” - 15” (30cm - 38cm)

15.5” - 17” (39cm - 44cm)

SUPPORT ROD GUIDE FOR TIRE SIZES

STEP 6

Aligning Wheel Pads to Fit Mower

• Place the front tires of mower 6” in front of the Wheel Pads.

• Remove Push Pins and align the Wheel Pads so that the front

mower tires will be centered on the Wheel Pads.

• Replace the Push Pins to lock the Wheel Pads to the Lift Arm.

Wheel Pads must be equal distance from the Lift Arm to

maintain proper balance.