Use and Care Manual

MoJack WorkBench MoJack WorkBench
8 9
Operating Instructions for use with MoJack EZ and MoJack XT
STEP 3
Raising the Mower
• Raise the mower by rotating the Crank Handle clockwise.
Do not attempt to lift more than 200 lbs.
The MoJack must be used on a solid level surface.
The mower engine must be turned off.
If using the WorkBench Inserts, do not install past
safety sticker.
STEP 5
Lowering the Mower
• Pull and hold the Carrier Locking
Pin out and turn the Crank Handle
counterclockwise until Wheel Pads
are firmly on the ground. The Carrier
Locking Pin must be pulled out until
it clears the bottom Safety Hole.
Safety Holes
Safety Hole
Carrier
Locking
Pin
Pull Out
to Unlock
and Lower
Tower Locking Pin
STEP 4
Raising Lift Arm to Locking Position
• Raise the Lift Arm until the Carrier Locking Pin drops into the
Safety Hole.
• The Carrier Locking Pin automatically drops into the Safety Holes as
the Carrier passes the Safety Holes on the Tower when raising.
• Note: When lowering the Lift Arm, the Carrier Locking Pin must be
held out by the operator until it clears the bottom Safety Hole.
Safety Hole
Carrier
Locking
Pin
Pull Out
to
Unlock
and
Lower
Operating Instructions for use with MoJack EZ and MoJack XT
STEP 1
Move push mower onto sleds
• With the carrier arm fully lowered, lift the front
end of the push mower onto the sleds and
then move the push mower so that the front
wheels of the push mower are touching the
front of the sleds.
• Secure the push mower to the sleds by
attaching the Clevis Pin and Hair Pin
as shown.
5 6
Front wheels
touching front
of sled
Clevis Pin
5
Hair Pin
6
STEP 2 (Optional)
With the WorkBench inserts secured between
the sleds. Place desired object to be lifted
onto the inserts.
WorkBench Insert
WorkBench Insert