Product Manual

MoJack XT Lift
18
STEP 21
Raising the MoJack XT with a power drill (optional)
• The MoJack XT can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 3/8” square driver (not provided).
• Remove Crank Handle by taking out the nut and bolt
which reveals the 3/8” Square Receiver.
• Firmly insert the 3/8” driver in the Square Receiver.
Rotate the drill forward (clockwise) to raise
the Lift Arm and rotate the drill in reverse
(counterclockwise) to lower the Lift Arm.
• Carrier Locking Pin must be pulled out when
lowering until it clears the bottom Safety Hole.
• Follow all other operating instructions while using the
drill attachment.
• Replace the Crank Handle for future use.
Operator must have a firm grip on the drill before
raising or lowering the Lift Arm.
3/8”
Square
Driver
Square
Receiver
Screw
Thread