User guide

3
Warnings and Safety Instrucons
IMPORTANT: The mower li is intended for use with mowers only. Do not exceed 500 lbs. (226 kg) front end weight. It
should never be used to service other types of machinery unless there is an approved accessory ed for the type of ma-
chinery. Please consult your local John Deere Dealer or distributor.
Read and understand all safety and operang instrucons before using the mower li.
Never allow anyone unfamiliar with the safety or operang instrucons to use the li.
Follow all safety and servicing instrucons provided by the lawn mower’s manufacturer before using the li.
Do not modify the li in any way. Any modicaons will void any and all warranes and could compromise
your personal safety.
When using the li, keep ALL bystanders at a safe distance away from the mower li.
The li must be used on a solid level surface.
Only li the FRONT end on the mower.
Do not li the front end and back end of the mower at the same me.
Only use the li for mowers that are less than 500lbs (226 kg) front end weight and properly ts in the
provided wheel pads. (ie. 10” to 17” diameter and within outside wheel measurements of 31.5” to 62.5”).
Always stop engine and remove key before beginning any work on the mower.
Always place mower in neutral or disengage the hydraulic drive by following the mower owner’s manual.
Never operate the engine while using the mower li.
Do not exceed the liing capacity of 500 lbs. (226 kg) front end weight. If you have a queson regarding weight of your
machine, please contact the manufacturer at 1-877-575-3173 or a local John Deere Dealer.
If the li Tower is leaning while liing or lowering the mower, this indicates an overload condion.
REMOVE THE MOWER IMMEDIATELY.
Tower must be secured in place with the Tower Clevis Pin before using the li.
Carrier Locking Handle must be locked into Tower before starng any service on mower.
Do not remove safety warnings or decals from li.
Before each use, always check for any worn, loose or damaged parts on the li. If any damaged parts
are present, do not use the li and consult a John Deere Dealer or distributor.
Do not climb on mower while it is lied, being lied or being lowered.
No one should be on the mower while it is lied, being lied or being lowered.
Aer the mower is raised to a working height, always place wheel chocks (not included) behind the back res of the
mower.
Wheel Pads must be equal distance from the Li Arm to maintain proper balance.
Always secure front mower res with enclosed safety straps.
Remove all mower aachments before using the li. Remove all front mower aachments (ballast, bumper or brush
guard) that interferes with handle before using the li.
Some mowers which are equipped with a fuel tank vent may spill fuel when lied. If this happens, run fuel level down in
the tank to prevent spilling.
Always use proper personal protecon equipment.
Failure to follow these warnings may result in property damage and serious bodily injury or death.