User guide

18
Raising the jack with a power drill (oponal –
power drill not included)
The jack can be raised or lowered by using a variable
speed corded drill (7 amp minimum) or variable speed
cordless drill (18V minimum). The drill will require a
3/8” square driver (NOT INCLUDED).
• Remove Crank Handle by taking o the Nylon Lock
Nut and Spring using 17mm wrench.
Aer Crank Handle removal, re-aach Spring and
Nylon Lock Nut to Crank Handle to prevent loss.
• Set the drill to the highest torque.
• Firmly insert the 3/8” square driver in the Square
Receiver. Rotate the drill forward (clockwise) to
raise the Li Arm and rotate the drill in
reverse (counterclockwise) to lower the Li Arm.
• Carrier Locking Handle must be manually pulled out when lowering
unl it clears the boom Tower Hole.
NOTE: Crank Handle must be removed in order to use the drill aachment.
Follow all other operang instrucons while using the drill aachment. Replace the Crank Handle as necessary for
future use.
NOTE: When re-assembling the handle, take care not to over-ghten the Nylon Lock Nut against the spring.
There should be enough free space for the handle to be pushed in to move from storage posion to operang posion.
NOTE: When re-assembling the handle, a “popping” sound may occur due to the re-engagement of the clutch system.
STEP 17
Operator must have a rm grip on the drill before raising or lowering the Li Arm.
3/8”
Square
Driver
Square
Receiver
STEP 18
Removing the Wheel Pads
• Remove Push Pins and
pull the Li Arm Inserts
and Wheel Pads out of the
Li Arm .
• Store the Push Pins in the
Li Arm and the Wheels Pads
to prevent loss.
Preparing for Storage (Steps 18 - 22)
Push Pin
Push Pin
Li Arm Insert
Li Arm
Wheel Pad
Operang Instrucons
When raising while
using the drill,
USE BOTH HANDS
AND GRIP FIRMLY!!