User guide

STEP 11

Strapping Front Mower Tires to Wheel Pads

• Secure the front mower res to the Wheel Pads

using the Safety Straps . Secure the hook on the

Safety Strap to the Wheel Pad Cross Bar. The Safety

Strap hook should always be facing upward.

Extend the Safety Strap over the top of re.

Insert the Support Rod into the loop on the

Safety Strap by detaching the Support Rod and

then sliding through the Safety Strap Loop and

reaaching the Support Rod.

• Tighten the Safety Straps over the top of the res

to secure mower to Wheel Pads.

NOTE: Inspect Safety Strap for wear before each use.

Operang Instrucons

Wheel Pad Cross Bar

Safety Strap

Using the Li (Steps 10 - 17)

STEP 10

Move mower onto jack

The jack must be used on a solid

level surface.

• Drive or roll the mower onto the Wheel Pads.

Stop engine and remove the key.

STEP 9

Reverse Front Tires of EZtrak™ (oponal – if not applicable, skip to Step 10)

• In some cases, the mower deck or an-scalping wheels will hit the

Li Arm while the mower is being raised. This is oen the case if

part of the deck (including the an-scalping wheels) protrudes past

the center line of the front wheels of the mower.

• Rotate the front res 180° so that they are in the reverse posion.

• Remove the Support Rods from the Wheel Pads and slide the

li underneath the mower.

• Secure the Support Rods to Wheel Pads with Large Hair Pins.

Reverse

Wheel

Posion

Forward

Wheel

Posion

Always secure front mower res with

enclosed safety straps.

Support Rod

Wheel Pad Cross Bar

Safety Strap

Support Rod