User guide

STEP 6

Familiarize yourself with the jack

• Pracce raising and lowering the Li Arm before aempng to

li the mower (see Steps 12 – 16 on how to raise and lower

the Li Arm).

• Pracce Step 17 if you intend to raise or lower the

mower with a drill aachment.

NOTE: Remove all front mower aachments (ballast,

bumper or brush guard) that interferes with handle

before using the li.

Operang Instrucons

STEP 8

Adjusng Support Rods for Proper Tire Size

• Adjust Support Rods on Wheel Pads to accommodate the

front re size of the mower. Please refer to the chart below

for proper Support Rod placement based on the diameter

of the mower’s front res.

• Secure Support Rods to Wheel Pads with Large Hair Pins.

Support Rod

Large Hair Pin

See page 21 for more more detailed guide.

10” - 11.5” (25cm - 29cm)

12” - 15” (30cm - 38cm)

15.5” - 17” (39cm - 44cm)

SUPPORT ROD GUIDE FOR TIRE SIZES

STEP 7

Aligning Wheel Pads to Fit Mower

• Place the front res of mower 6” in front of the Wheel Pads.

• Remove Push Pins and align the Wheel Pads so that the front

mower res will be centered on the Wheel Pads.

• Replace the Push Pins to lock the Wheel Pads to the Li Arm.

Wheel Pads must be equal distance from the Li Arm to

maintain proper balance.

When using the li, keep ALL bystanders at a safe

distance away from the mower li.