Use and Care Manual

MoJack PRO Lift
17
Operating Instructions
STEP 21
Raising the MoJack PRO with a power drill (optional)
• The MoJack PRO can be raised or lowered by using a
variable speed corded drill (7 amp minimum) or variable
speed cordless drill (18V minimum).
• The drill will require a 7/16” socket (not provided).
• Remove the Winch Handle by removing the
Nylock Nut and Winch Handle Washer.
Firmly place the 7/16” socket on the Drill Reducer.
Rotate the drill in reverse (counterclockwise) to raise
the Lift Arm and rotate the drill forward (clockwise) to
lower the Lift Arm.
Ratchet Release Handle and Grip Handle must be
squeezed together when lowering the Lift Arm.
Follow all other operating instructions while using the drill attachment.
Replace the Winch Handle for future use.
Operator must have a rm grip on the drill before
raising or lowering the Lift Arm.
Drill Reducer
7/16” Socket
Remove Winch Handle
STEP 20
Folding the MoJack PRO
• Pull locking pin out to unlock.
Raise the Tower out of the Base by pulling up on
the
Grip Handle and then lower the Tower.
The tower will be securely locked in place when the
locking pin retracts.
THE MOJACK PRO IS NOW READY FOR STORAGE OR TRANSPORT.
Tower Locking
Pin
(unlocked position)
Lift Tower
out of Base
Tower Locking
Pin
(locked position)