Installation Guide

866.729.2378 | www.moistureshield.com 41
DECK CLIP SYSTEM
INSTALLATION INSTRUCTIONS
COMPLETE SYSTEM
COVERS 50 SQUARE FEET OF DECKING
• 5 starter clips
• 5 finish clips
• 90 clips
• 90 screws or 90
pneumatic fasteners
DECK/CONTRACTOR PACK
COVERS 250 SQUARE FEET OF DECKING
• 450 clips
• 500 screws (Deck Pack) or 500
pneumatic fasteners (Contractor
Pack)
*Does not include starter or finish clips
866.729.2378 | WWW.MOISTURESHIELD.COM
BENEFITS:
• Easiest clip to install with square drive ACQ compatible screws or pneumatic fasteners
• Concealed deck clips allow for an unblemished deck surface
• Base of clip elevates board off the joists, reducing rot, mold, ice shear and lateral load stress
• Automatically spaces the deck boards 3/16” for a uniform appearance
• Limited Lifetime Warranty against loose deck boards
• Available in high strength steel with a patented coating process to resist corrosion or 304
grade stainless steel for coastal applications
• Approved for ACQ joists and all other PT joists
*All clips available in stainless steel
POST LIGHTS
INSTALLATION INSTRUCTIONS
6. We recommend predrilling the wire hole and holes for the
m o u n t i n g s c r e w s t o p r e v e n t s c r a c k i n g i n t h e s u r r o u n d i n g
material. Use a drill bit that is smaller than the screw
to ensure the screw will hold. If passing wire through
and making connection under a post cap or below your
decking, use a 1/4” drill bit.
TIP: Run wire through post and double check mounting
screw placement before predrilling these holes.
7. Thread the wire from the fixture through 1/4” hole and run it
where it needs to go. Install the fixture in place using mounting
screws.
NOTE: For the Hourglass light,
you will install mounting screws first and slide light down post to meet screws
and secure mounting. If it is not a tight fit, remove the fixture and slightly tighten
screws on the post.
8. Cut and snip fixture wires and main wires to comfortable working
length. Then connect with a UL-approved silicone filled wire-nut. Be
sure at least 7/16” of copper wire is exposed and wire nuts are on
securely. Loose connectors can arch, causing fixture failure or fire.
NOTE: Silicone-filled wire nuts are not included with fixture.
POST LIGHTS
INSTALLATION INSTRUCTIONS