Installation Guide

ManualsBrandsMoistureShield ManualsComposite Decking BoardsVision 1 in. x 5-3/8 in. x 16 ft. Mochaccino Cooldeck Grooved Edge Composite Deck Board

866.729.2378 | www.moistureshield.com 38

DECK CLIP SYSTEM

INSTALLATION INSTRUCTIONS

COMPLETE SYSTEM

COVERS 50 SQUARE FEET OF DECKING

• 5 starter clips

• 5 finish clips

• 90 clips

• 90 screws or 90

pneumatic fasteners

DECK/CONTRACTOR PACK

COVERS 250 SQUARE FEET OF DECKING

• 450 clips

• 500 screws (Deck Pack) or 500

pneumatic fasteners (Contractor

Pack)

*Does not include starter or finish clips

866.729.2378 | WWW.MOISTURESHIELD.COM

BENEFITS:

• Easiest clip to install with square drive ACQ compatible screws or pneumatic fasteners

• Concealed deck clips allow for an unblemished deck surface

• Base of clip elevates board off the joists, reducing rot, mold, ice shear and lateral load stress

• Automatically spaces the deck boards 3/16” for a uniform appearance

• Limited Lifetime Warranty against loose deck boards

• Available in high strength steel with a patented coating process to resist corrosion or 304

grade stainless steel for coastal applications

• Approved for ACQ joists and all other PT joists

*All clips available in stainless steel

INSTALLATION INSTRUCTIONS

Drill a 3/8” hole all the way through the deck in the center of

the 3” hole. Next, run the fixture wire through the 3/8” hole to the

underside of the deck where wire connections will be made.

NOTE: Tabs on the outside of the 3” back box must be removed

with a flat head screw driver. DO NOT drill 3/8” side holes.

Install back box by removing the face plate, inserting back into 3” hole and

screwing through the two slots in the back of the box. Be sure box is installed

straight or the face plate will be crooked.

Install face plate using finished screws and rubber washers

provided. Make sure rubber washer is between the screw and

the faceplate. Hand tighten faceplate screws until screws are just

slightly snug or glass face will break

Cut and snip fixture wire and (2) main wires to comfortable working length and

connect with a UL-approved silicon-filled wire nut. Be sure at least 7/16” of copper wire

is exposed and wire nuts are on securely. Loose connectors can arch, causing fixture

failiure or fire.

NOTE: Silicone-filled wire nuts do not come with fixture. They can be purchased at your

local hardware or lumber store.

STAIR LIGHTS

INSTALLATION INSTRUCTIONS