Installation Guide

866.729.2378 | www.moistureshield.com 33
DECK CLIP SYSTEM
INSTALLATION INSTRUCTIONS
COMPLETE SYSTEM
COVERS 50 SQUARE FEET OF DECKING
• 5 starter clips
• 5 finish clips
• 90 clips
• 90 screws or 90
pneumatic fasteners
DECK/CONTRACTOR PACK
COVERS 250 SQUARE FEET OF DECKING
• 450 clips
• 500 screws (Deck Pack) or 500
pneumatic fasteners (Contractor
Pack)
*Does not include starter or finish clips
866.729.2378 | WWW.MOISTURESHIELD.COM
BENEFITS:
• Easiest clip to install with square drive ACQ compatible screws or pneumatic fasteners
• Concealed deck clips allow for an unblemished deck surface
• Base of clip elevates board off the joists, reducing rot, mold, ice shear and lateral load stress
• Automatically spaces the deck boards 3/16” for a uniform appearance
• Limited Lifetime Warranty against loose deck boards
• Available in high strength steel with a patented coating process to resist corrosion or 304
grade stainless steel for coastal applications
• Approved for ACQ joists and all other PT joists
*All clips available in stainless steel
STRIP LIGHTS
INSTALLATION INSTRUCTIONS
COMPLETE KIT INCLUDES:
• 4 6-foot LED Strip Lights
• 12 Connectors
• 100’ of Twisted Wire
• 3 AMP Transformer with Power Cord
(operates up to 24 lineal feet of strip lights)
• Remote Driver
• Remote Control
TOOLS NEEDED:
• Power Drill
• Screwdriver
• 3/8” Bit
• 3/16” Bit
• Tape Measure
• Eye protection
• Aluminum strip housing (sold separately)
• Silicone-filled wire nuts
REQUIREMENTS:
Before you begin, make sure you have an external,
weatherproof, protected 110 volt outlet that meets
GFCI (ground fault circuit interrupter) standards.
Mount the transformer at least 10 inches above the
ground. Best results can be achieved when you have
access to the underside of your deck or installation
surface.
STRIP LIGHTS
INSTALLATION INSTRUCTIONS