Installation Guide
866.729.2378 | www.moistureshield.com 32
BULLET LIGHTS
4. To install a light module, untwist the wire coming up from below the hole in the center of the slack. There is no need to cut or
strip the wire. Use two green connectors for each light. First insert the black twisted wire into the open side of a connector so
that it fits snugly in the space provided. It will go all the way through the connector. Then take the black wire from the light and
insert it into the other hole in that connector. Push the wire from the light in until it stops.
5.
gray twisted wire and the gray wire from the light fixture using another green connector.
Connect all lights to the wire in this manner.
6. Once all of the LED deck lights have
been connected to the wire, connect the end of the twistedwire to the
from the transformer.
7. When all lights are installed, cap the ends of the twisted wire separately
with the red connectors.
Do not connect the ends together as this will short out the system. Plug
in the power source to make sure all lights are working properly. Unplug before
proceeding to the final steps.
8.
light fixtures and feed the wires back through the hole and place the fixture into
place. Make sure the module is flush with the decking.
Plug in the power cord, and operate using either the remote control or the
light switch.
TROUBLESHOOTING TIPS:
1. Make sure all wires are connected in like color pairs. Make sure the remote control has a battery and it is installed correctly.
If you choose to bypass the remote, be sure to remove the remote driver from the set-up and connect the twisted pair wires
directly to the power box.
2.
nodules of a 9 volt battery.
LED DRIVER BOX
RED END OF CHAIN CAP
A
B
C
SHOWS THE CONNECTIONS FROM UNDER THE DECK
SILIC
ONE
LED DRIVER BOX
REMOTE CONTROL DRIVER