Installation Guide
866.729.2378 | www.moistureshield.com 31
BULLET LIGHTS
INSTALLATION INSTRUCTIONS
Use eye protection when using power tools. Do not install within 10
feet of a pool, fountain or spa.
1. Mount the transformer 18 inches above the ground near your outlet using
screws. Do not plug it in.
2. Determine the spacing
of your lights on your deck. Be sure to avoid positioning lights over joists
and headers or on spacing gaps. For best results, place your lights three
to six feet apart. Keep in mind that your farthest light can be no more
than 100 feet from the transformer using the wire included in the kit.
upside down in the hole until the shoulder is flush with the decking
surface. The bottom of your hole needs to be flat so the light lays in correctly. If necessary, use a chisel to scrape away excess
decking. This creates the hole for the base of the light and for the wires. Drill all holes to size.
The custom MoistureShield
®
forstner bit has a dual design that will allow you to do both of these
upside down in the hole until the shoulder is flush with the decking surface.
3. Starting with the hole farthest from the power source, run the 100 feet of twisted cable wire below
the deck and up through each hole, leaving six inches of slack above deck to allow for connections.
The farthest end of the wire will be capped with a red connector at
the end of your installation.
TIP: If installing multiple lights make a mark on the bit once you reach the
correct depth to use a line for the other installations. The initial installation
can also be performed on a scrap piece of board to ensure the correct depth
before installing on the deck.
1 ”
1/8
3/4”
REMOTE CONTROL DRIVER
LED DRIVER BOX
6”