Installation Guide

866.729.2378 | www.moistureshield.com 24
RAIL INSTALLATION:
1. Carefully measure the opening between posts or walls and calculate the length of rail that needs to be cut. Divide the trim length

baluster spacing or personal preference, all of the trim length could be cut from one end of both rails. Make this determination before
cutting the rails.


2.             

Note: One support block, cut from support block material (F), is recommended for rails
measuring 72” in length or less; two support blocks for longer lengths. If one support block is
required, install the support block connector (G) at center point of bottom rail (B]. If two support
blocks are required, install support block connectors (G) equal distance from each end of the
bottom rail (B).
3.
Firmly tap each baluster with a rubber mallet to ensure the baluster is fully seated against
the top rail.
Note: It is recommended to use the box as a pad to prevent scuffing of the painted finish. If
installing square balusters, make sure they are properly seated in the slot on the underside of
the top rail to prevent twisting.
4.
assembly upside down on the surface of the box and firmly tap the bottom rail with a rubber mallet to
secure the balusters in place. Stand assembly upright.
5.

6. The MoistureShield
®



Note: If installing with a deck board on the top rail (A) reduce the above dimensions by the
thickness of the deck board being used. Overall rail height may vary by local code or personal
preference.
7.

8.
7. Pre-drilling is recommended.
Note: If installing a deck board on the top rail (A), omit Step 9 and do not install the rail caps.