Instructions / Assembly

866.729.2378 | WWW.MOISTURESHIELD.COM
Attach posts to decking frame. Square to straight side
of rim joist and level. Slip post collar over post onto deck
if installing.Follow procedures 2-4 to install posts and
decking.
Determine the angle of the top magnum rail.
A. Lay a top magnum rail centered on top of the two posts
and mark angle (see railing orientation) and cut.
B. Mark and cut the bottom magnum rail the same way,
making sure to lay the 4-inch leg on the posts.
A. Place bottom magnum rail on blocks that are cut to the
toe sweep height desired (no less than 2-inches nor greater
than 4-inches) – 4-inch leg lying on blocks.
B. Place baluster with 45-degree cut side against the post
positioned at the 45-degree corner and sit on the bottom
magnum rail. Attach it to the post using procedure #1C.
C. Place a regular baluster against the diagonal baluster,
sitting on bottom magnum rail and attach with three, 2-1/4-
inch, #7 stainless steel trim head screws, evenly spaced top
to bottom.
Finish with steps #1D through #7 from the composite railing
installation instruction – with the exception of the post
baluster that has been installed already in this 45-degree
section (step #2).
1.
2.
3.
4.
45-DEGREE RAILING
INSTAL LATION