Owner`s manual

7
Water Fill (continued)
Each water bottle is designed with a
“Side-Fill Cap” that is easily removable.
Remove the “Side-Fill Cap” on the side of
the water bottle by twisting
counterclockwise.
Place the opening of the water bottle
under a water faucet (the bottle should fit
under a four-inch clearance faucet). Fill
with recommended mixture of cold water
and Bacteriostat (if necessary) only. Solid
debris could make the valve leak.
Install the “Side-Fill Cap” by twisting
clockwise. Hand tighten only.
Check for possible leaks by
performing the following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on the valve cap plunger for
about one second to let out a little
water.
3. Release the plunger.
4. Listen for air bubbles Look for leaks
around the “Side-Fill Cap”.
5. If you hear air bubbles or see leaks,
retighten the “Side-Fill Cap” and
repeat Steps 1-4.
Pivoting Lid Removed for Clarity
Raised
Section
Right
Bottle
Turn Counterclockwise
to Remove Cap
Valve Cap
Plunger
Wipe off excess water from the bottle.
Position the water bottle back into the unit
by grasping the water bottle handle and
lower it into the cabinet until the bottle
sits on pads at bottom of cabinet. The
“Side-Fill Cap” must be facing the rear of
the cabinet. When positioned properly,
the plunger will open and water will flow
into the cabinet.
The water le
v
el will
automatically remain at approximately
1/2” until the bottles are empty.
Allo
w the filter to satur
ate f
or 30 min
utes
before operation.
SP6647.qxd 7/5/06 8:23 AM Page 7