Installation Instructions

1.10.4 Mohawk Laminate Installation Guide
End Profile/Square Nose
First, cut the profile to the correct length and use the knife to remove piece
B to obtain the end profile/square nose molding. Please note: The edge of
the cut profile can be very sharp. Be sure to wear gloves when handling
the raw edges, and sand the edges prior to installation.
When installing against a vertical surface, cut the plastic rail to the correct
length and fit it on top of the subfloor with the short lip against the vertical
surface. The short lip serves as a spacer. Ensure that there is a sufficient
gap between the floor and the raised legs of the rail into which the profile
will be clamped. Gently press from one side of the rail to the other, and then press against the floor.
If you’re installing against a horizontal surface, follow the directions for the reducer profile.