Installation Instructions

1.10.2 Mohawk Laminate Installation Guide
INSTALLING MOHAWK’S INSTAFORM™
Decide which profile of the three available profiles you wish to use and use the enclosed cutting/sanding
tool to remove the one or two pieces of the profile necessary to obtain an adaptor, an end, or an expansion
profile. Slide the cutting tool in a smooth movement on the length of the profile, and then take off the piece
to be removed. Sand any unevenness by using the sander found on the edge of the tool.
Please note: The edge of the cut profile can be very sharp. Be sure to wear gloves when handling the
raw edges, and sand the edges prior to installation.
Installing the Plastic Rail
The molding profile you select will be put in place via the included plastic rail (formerly called “mono-
track”). You’ll attach the rail to the floor and then press the molding into place. You can use screws to attach
the plastic rail to the floor. Use the pre-drilled holes between the raised legs of the rail, but be aware of any
pipes that may be in the floor below.
Please note: For installation of floors of more than 9 mm,
snap off the long lip of the rail at the notch over the entire
length of the rail. Insert this lip under the rail to compensate
for the different in height with the floor. Firmly anchor both
pieces to the ground with screws.