Installation Instructions

PERFECT
SEAL
PerfectSeal
Installation Guide
Waterproof Laminate Flooring
This document is reviewed on an ongoing basis.
SV_0878 7/20
Vertical Wainscot Style Wall Install Instructions (cont’d)
8. Apply silicone adhesive to the back side of the plank in an “S” pattern. If you’re using a laminate plank with an attached pad,
apply the silicone directly to the pad on the back of the plank. (Figure 3)
9. Adhere the plank to the wall leaving a 3/16" gap (A) from the corners of the wall and a 1" gap (B) at bottom. Drive brad nails
1/2" from the top and bottom of each plank to secure to wall. Place nails where the trim will covers.
10. Continue with the installation for each subsequent plank by rst applying silicone adhesive to the back side of the plank in an
“S” pattern. Then angle the groove over the tongue of the previous plank and wiggle into place. Tighten joints as needed with
a tapping block or pull bar. Finally, drive brad nails 1/2" from the top and bottom of each plank to secure to wall. Place nails
where the trim will cover. Be sure to drive the brad nails into a stud whenever possible.(Figure 4)
11. Finish accent to ending wall. (Figure 5)
12. Install trim (chair rail) over the top edge. Install quarter round in the corners. Finish by installing the baseboard of your choice.
(Figure 6)
9