Installation Instructions
PERFECT
SEAL
PerfectSeal
Installation Guide
Waterproof Laminate Flooring
This document is reviewed on an ongoing basis.
SV_0878 7/20
Wall Installation Instructions
Although originally designed as a durable oor covering, many consumers have started using Mohawk laminate ooring on walls to
give their rooms more character and to create a feature or accent wall.
Laminate can be utilized as a decorative covering over an existing clean, dry, secure and vertical wall that meets building codes. The
wall substrate should be primed or painted drywall (gypsum board) only. Do not install directly over wallpaper or paneling. Laminate
is not intended to be used on ceilings, countertops or as any type of structural material.
The installation wall should only run vertical to the oor. Sloping walls and surfaces that are parallel to the oor, such as ceilings or
softs, should not be selected. Limit installations to a maximum of 40 feet in length and a maximum of 1 plank length in height.
Laminate is suitable for an accent wall when used in climate controlled (35-65% RH and 60-85° F) indoor installations only. Acclimate
unopened product lying at in the room where it is to be installed for at least 48 hours. Mix planks from different cartons as you install
to maximize the natural appearance.
Check wall for moisture, visible water stains or leaking windows. Do not install laminate over a wall with known moisture damage. Do
not install in areas near water sources such as a backsplash over a sink or bathtub. Acceptable job site conditions, including relative
humidity and wall moisture conditions, must be maintained throughout the life of the laminate application.
Check wall for atness within 3/16" over 10 feet. Correct any unevenness before installing to allow the laminate planks to lie at
without rocking.
The following requirements are not intended to supersede federal, state or local building codes, but as with many other interior
nish products, may require modifying existing structural components for successful installation. Owner assumes responsibility for
compliance with all building codes, including maintaining the required distance from heat sources such as replaces.
WARNING: For a safe and secure installation, this product MUST be installed in accordance with these installation instructions.
Tools Required for Installation:
• Caulk gun
• Utility knife
• Stud nder (electronic)
• Carpenters level or laser level
• Chalk line
• 18 gauge brand nail gun (electric or air)
• Tape measure
• Pencil
• Screw gun or drill driver (for horizontal installation only)
• Safety glasses
• Dust mask
• Gloves
7
Materials Required for Installation:
• 1 ½" - 1 ¾" brad nails
• 100% silicone adhesive caulk (clear)
• 1 ½" - 1 ¾" dry wall screws (for horizontal installation only)
• Painters tape (for horizontal installation only)
Other Tools and Materials:
• Step ladder (for horizontal installation only)
• Hammer
• Uniclic® appropriate tapping block
• Chalk line
• Pull Bar
• Saw for cutting laminate planks
• Pry bar (for removing existing base or trim)
• Chair rail (for vertical installation only), wall base and quarter
round moldings (to fame out accent wall)