Installation Guide

aladdin-commercial.com

1.800.2MOHAWK

5. The remaining portion of the rst breadth can now be folded or rolled back from the oor. Apply NuBroadlok to the

oor; wait until the adhesive has reached the proper tacky stage before dropping the carpet into place. Be sure to have

enough people spreading the adhesive so that, after the oor is covered with adhesive, each breadth is in place within the

determined period of open time.

6. Roll or fold back the dry portion of the second breadth toward the seam, spread the NuBroadlok, and place the carpet to 3

feet from where the next seam will fall.

7. Be sure to roll out looseness and air bubbles as the carpet is put in place. Repeat above procedures on continuing breadths.

To trim the carpet at the wall, use a razor-blade knife or suitable wall trimmer.

8. Roll completed installation with a 75 lb. to 100 lb. roller in both length and width. This will allow the adhesive to penetrate

the carpet back properly.

PLEASE NOTE: Mohawk Industries’ branded adhesives are required to ensure optimum results and are the only approved

adhesives that Mohawk Industries will warrant. Failure to use Mohawk Industries’ branded adhesives can result in warranties

being null and void.

This information, offered as a customer service, is based on Mohawk Industries’ engineering tests and eld experience. It is intended for installers

with professional experience, to be used at their discretion and risk. Mohawk Industries does not guarantee results and assumes no liability in

connection with these installation instructions.