Installation Instructions

Application
This product is only suitable for the applications marked with a ☑.
☑ Interior walls
☐ Interior oors
☑ Interior wet wall applications (shower walls)
☐ Interior wet oor applications (shower oors)
☐ Exterior walls*
☐ Exterior oors*
Installation
It is recommended to use a white thin-set mortar with a exible acrylic additive (or a white polymer fortied
thin-set mortar). Apply this mixture with the manufacturer’s recommendations of a notch trowel (typically
3/16”x3/16” V-notch and then knock down the trowel ridges with the at side of the trowel to produce an
even layer of thin-set mortar). Spread only enough thin-set to install a few sheets at a time. Back-butter each
sheet with the at edge of the trowel. Be sure to achieve full coverage on the back of the tile. Carefully,
press into the thin-set leaving even spaces in between tiles. A grout oat can be used to tap the tiles into
place. We recommend to allow a 1 /8” joint between tiles. Allow for movement joints where the tiles abut
restraining surfaces and around the perimeter of the installation. Grout with a sanded grout after the
adhesive has had proper time to cure according to the manufacturer’s recommendations.
Cutting
A ceramic tile wet saw is recommended. Whenever possible, cut edges should be placed in corners where
they can be hidden.
Drilling
It is recommended to use a drill bit that is especially designed for ceramic. The tile must be securely
clamped into place to prevent movement of the tile during the drilling process. When drilling the hole,
keep the bit and hole lubricated to prevent chipping. It is recommended to drill from both sides of the tile,
starting with the back and drilling half of the depth of the tile. Then, turn the tile over and complete the hole.
This will prevent the stone and glass from chipping as the drill bit exits the tile.
Sealing
Seal the grout only. Clean the sealer off the tile before it dries.
Cleaning
It is recommended to use a non-abrasive cleaner to prevent scratching of the tile. Tiles that have been
scratched prior to or during installation are the customer’s responsibility.
*in freezing and non-freezing climates only when proper installation methods are followed
GLAZED CERAMIC MOSAIC
INSTALLATION AND CUTTING GUIDE