Installation & Assembly

0372ES | 04/2019 | Page 4/4MOHAWK TECHNICAL SERVICES DEPARTMENT | 508 EAST MORRIS STREET, DALTON, GA. 30721 | 888.387.9881
Uniclic
®
Installation Instructions
9. Continue installing planks and make sure to achieve a random appearance with end pieces of minimum 6 (15 cm). Check that all planks are fully
engaged; if a slight gapping is found, the gap can be tapped together by using a tapping block and a scrap of ooring to cover the tapping block in
order to avoid damages on the planks.
10. When tting under door casings, etc., the exibility and convenient connection of Uniclic becomes evident. If necessary, a fat pull bar may be used
to assist in locking the planks. If needed, remove the locking prole on the groove in order to slide the plank into place and apply seam sealer to the
edges to glue planks together.
11. When tting around obstacles or into irregular spaces, the product can be cut easily and cleanly using a utility knife with a sharp blade. It is often
benecial to make a cardboard template of the area and transfer this pattern to the plank.
12. Protect all exposed edges of the ooring by installing wall molding and/or transition strips.
Make sure that no plank will be secured in any way to the suboor.
13. Protect the nished installation from exposure to direct sunlight or the tiles may peak or shift.
14. For wet areas such as bathrooms, caulk the perimeter of the oor with a silicone caulk
Approved Methods for Tile and Plank:
In cases of severe damage, tiles may be replaced by cutting the bad piece out using a utility knife. To insert a replacement tile, cut the tongue off the
new piece and use a seam sealer on only the sides of the tile, adhering the new tile into place.
Random Half Lap Ashlar
Plank Replacement
In cases of severe damage, tiles may be replaced by cutting the bad piece out using a utility knife. To insert a replacement tile, cut the tongue off the
new piece and use a seam sealer on only the sides of the tile, adhering the new tile into place.