Owner Manual

ManualsBrandsMohawk Flooring ManualsFlooringKearny Walnut 1/2" Thick x Random Width x Varying Length Engineered Hardwood Flooring

Installation Instructions

For Mohawk Engineered Hardwood oors with Ply Construction

Uses

• Protection from concrete moisture up to 95% RH

• Sound reduction in multi-story buildings

• Crack suppression for in plane cracks up to 1/8" wide

IMPORTANT: Only the above specified trowels and application methods are to be used with this adhesive; otherwise, the product performance warranties

and liabilities will be made void. Use of these products or products with equal or greater specifications are necessary for warranty compliance.

M808 Tri-Polymer Adhesive

A high tri-polymer formula adhesive for the installation of engineered wood flooring over a variety of properly prepared substrates, including concrete, APA

approved subfloor panels, sheet vinyl, VCT and clean abraded terrazzo

Wood

Wood substrates should test less than 12% using a pin moisture meter.

Concrete

• Up to 85% RH levels in concrete using in-situ probes in accordance with the latest version of ASTM F 2170

• pH test results between 7.0 and 9.0

• Test for sealers and curing compounds

Wood substrates should test less than 12% using a pin moisture meter. Use a 3/16" x 1/4" x 1/2" flat V-notch trowel. Trowel should be replaced every 3,000

square feet or sooner as wear dictates. Approximate coverage is 200 to 220 square feet per 4 gallons.

Concrete substrates should test less than 85% RH. Use a 3/16" x 1/4" x 1/2" flat V-notch trowel. Trowel should be replaced every 3,000 square feet or sooner

as wear dictates. Approximate coverage is 200 to 220 square feet per 4 gallons.

Coverage is based on application to a clean, smooth concrete substrate. Application rate may vary depending on substrate conditions.

Uses

• For protection from concrete moisture up to 85% RH

• Will not etch the nish on a pre-nished board.

• May be used on properly prepared concrete or wood substrates.

IMPORTANT: Only the above specified trowels and application methods are to be used with this adhesive; otherwise, the product performance warranties

and liabilities will be made void.

M92X Modified Moisture Cured Urethane Adhesive

A trowel-applied moisture curing urethane adhesive for the installation of glue down flooring installations over concrete and wood substrates.

Wood

Wood substrates should test less than 12% using a wood moisture meter.

Concrete

• Up to 90% RH levels in concrete using in-situ probes in accordance with the latest version of ASTM F 2170

• Test for sealers and curing compounds

Use a 3/16" x 1/4" x 5/16" V-notch trowel. Approximate coverage is 50 to 60 square feet per gallon.

Coverage is based on application to a clean, smooth concrete substrate; therefore, application rate may vary depending on substrate conditions.