Installation & Assembly

ManualsBrandsMohawk Flooring ManualsFlooringModern Comfort Oak 4/7" Thick x 7" Wide x Varying Length Engineered Hardwood Flooring

Installation Instructions

For 3/8”, 1/2”, and 9/16” Mohawk oors with Enhanced Engineered Construction

™

Uses

• For protection from concrete moisture up to 85% RH

• Will not etch the nish on a pre-nished board.

• May be used on properly prepared concrete or wood substrates.

IMPORTANT: Only the above specified trowels and application methods are to be used with this adhesive; otherwise, the product performance warranties

and liabilities will be made void.

M92X Adhesive

A trowel-applied moisture curing urethane adhesive for the installation of glue down flooring installations over concrete and wood substrates.

Use a 3/16" x 1/4" x 1/2" V-notch trowel. Approximate coverage is 50 to 65 square feet per gallon.

Coverage is based on application to a clean, smooth concrete substrate; therefore, application rate may vary depending on substrate conditions.

NOTE: Do not apply over self-stick tile, sheet vinyl, old adhesives, metal, linoleum, laminate, particleboard or strip wood subfloors without first covering with

an approved wood or wood composite underlayment. Air temperature must be between 50° and 100°F for applying M92X Urethane Adhesive.

• Product must be used in its entirety when opened. Lid cannot be re-sealed.

• Temperature and humidity will affect the curing time. The higher the temperature and humidity, the faster the cure.

Application

1. Regulate temperature and humidity 72 hours before, during and after installation.

2. Spread adhesive using recommended trowel, ensuring 95% to 100% adhesive contact.

• Wet lay method: Press ooring rmly into adhesive immediately after troweling.

• Walk on method: Press ooring rmly into adhesive after it has developed its initial grab, typically after 15 to 20 minutes.

3. Remove any adhesive smudges or drops immediately, as adhesive is very difcult to remove once allowed to dry. Clean tools while adhesive is fresh

using a urethane adhesive remover or mineral spirits.

4. Avoid light/regular foot trafc for at least 12 hours. Avoid heavy foot trafc for at least 24 hours.

Use clean white terry cloth towels with mineral spirits to clean as you go. It is easy and convenient to use. Adhesive that has cured on the surface of the

ooring can be difcult to remove.

Getting Started — Direct Glue

There are two ways to install when using a moisture cured urethane wood flooring adhesive: the wet lay method, laying flooring directly into wet adhesive,

and the dry lay method, which allows the adhesive to flash or to tack up.

CAUTION: Whether you choose to install using the dry or wet method, follow all guidelines set by the adhesive manufacturer as well as the flooring

manufacturer. Failure to adhere to the guidelines may void your flooring warranties.