User's Manual

www.mog-technologies.com
PAGE 9 | 25
BrightVR Stream Model – User Manual
2.3 Initial SETUP
2.3.1 Connecting the WIFI Antenna
1. Turn OFF the Camera
1. Insert the Wi-Fi antenna into the
socket and screw it until it is securely
attached to the camera (no tools are
required for this procedure).
2.3.2 Inserting and removing a Memory Card
BrightVR camera comes with a 32 GB capacity memory card. A memory card must be inserted in the
camera slot to record videos or save your photos. Please note that some memory cards may not be
compatible with the device.
The following memory cards can be used, regardless of its capacity:
• SDHC memory cards* – Class 10 – speed grade U3 , to answer the demand for high resolution and high-
quality 4K video recording that the camera requires.
* Cards conforming SD standards.
Please note that not all memory cards have been verified to work with BrightVR camera.
Insert the Memory Card:
1. Turn the camera OFF;
2. Insert the memory card into the slot on the
bottom of the camera with the card contacts
adequately aligned with the ones from the
camera;
3. Push the memory card into the slot until it
locks in place.
Remove the Memory Card:
1. Turn the camera OFF;
2. Press into the slot with your fingernail,
3. The card will pop out.
2.3.3 Inserting, removing and Charging the Batteries
BrightVR camera comes with two rechargeable batteries that will provide power to the camera when
unplugged from the wall power outlet.
Memory Card Slot
Memory
Card