Specifications

Cleaning
13
Cabinet
Clean with a good quality stainless steel cleaning compound. Harsh abrasive cleaners may damage
the surface.
Side racks
To remove, take hold of the centre rung and lift upwards to disengage the rack key-holes from the
hanger studs. To replace, hold horizontally, engage keyholes onto studs and push down.
Door
Wash with warm water and detergent solution using a soft sponge in straight lines up and down the
door. Rinse with clean, warm water and dry off.
Clean door seal with warm water and detergent solution using a soft sponge when required.
Water tank
To remove lift RH side rack and pivot at rear, remove tank by lifting off its hanger studs. Clean with
warm soapy water. Rinse thoroughly and refit.
Water trough element
When the element becomes limed/scaled remove the water trough and clean. Replace water trough
and half fill with white vinegar or acetic acid, then fill to the normal level with water. Switch the unit on,
turn the humidity to ‘8’ and operate for approximately 30 minutes. Remove trough and clean the
element with a damp cloth when cooled. Rinse out the trough and refit to unit.
This procedure is recommended to be carried out once a week. Frequency of cleaning the element
may be increased or decreased depending on the lime depositing on the element.
Caution:
ALWAYS TURN OFF THE POWER SUPPLY BEFORE CLEANING.
THIS UNIT IS NOT WATER PROOF.
DO NOT USE WATER JET SPRAY TO CLEAN INTERIOR OR EXTERIOR OF THIS UNIT.
Cleaning Guidelines
Water trough access Water trough removal
1
2
1
2
Open right hand rack support.
1) Lift rack upwards to disengage keyholes.
2) Hinge on rear supports to open.
Lift out water trough.
1) Lift trough upwards to disengage keyholes.
2) Remove water trough.
gpd.sunwayinfo.com.cngpd.sunwayinfo.com.cn