User manual

25
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.
TO REPLACE THE OUTER DOOR GLASS
1. Holding the oven glass with both hands, gently
place the locators into the holes of the brackets
at the bottom of the oven door.
2. Holding the door glass with your left hand, use
your right hand to open the oven door.
Bring the door gently towards the glass panel
ensuring the screw location holes line up.
3. Place the trim in the correct position on the top of
the grill door.
4. Hold the glass in place with one hand and insert
the cross head screws with washers into the
location holes with the other hand. Give the
screws one turn to ensure the glass is secure.
5. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
DO NOT attempt to use the oven without
the glass being in place.
CLEANING THE INNER GLASS DOOR
The inner glass door is not removable. Clean using
hot soapy water or Hob Brite and a soft cloth. DO
NOT use abrasives as they may damage the glass or
seal.
CLEANING INSIDE THE OVEN AND
GRILL COMPARTMENT
The Stayclean surface on the rear oven panel in the
fan oven should not be cleaned manually.
The vitreous enamel in the grill compartment and the
fan oven base and sides can be cleaned using
normal oven cleaners with care. Ensure that the
manufacturers instructions are followed and that all
parts are well rinsed afterwards.
Aerosol cleaners must not be used on the
Stayclean rear oven panel and must not come
into contact with elements or the door deal as
this may cause damage.
During normal use the Stayclean coating will become
splashed with fats and food residues. By running the
oven without food, the Stayclean surfaces burn off
any soilage.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in the grill and oven
cavities can be removed for cleaning.
1. Remove all shelves and furniture from the grill
and oven compartments.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the grill or oven compartment.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace, hook the wirework runner back into
the grill/oven sides.
Ensure that the wirework runners are firmly
in place before refitting the oven shelves.
CLEANING THE SHELVES, WIREWORK
RUNNERS AND OVEN FURNITURE
Soak the oven shelves, wirework runners and grilling
grid in hot soapy water if heavily soiled, they will then
clean more easily. If the shelves are heavily soiled a
soap impregnated steel wool pad can be used.
The grill pan can be cleaned using a soap
impregnated steel wool pad.
All items of grill and oven furniture are dishwasher
safe with the exception of the grill pan handle.
CAVITY
CENTRE
SIDE PANEL