GAS COOKER GSC 5062 GB
CONTENTS Instructions for the user Instructions for the installer Important Safety Information 4 Safety Advice 18 Description of the appliance 5 Electric connection 18 Technical Features 6 Technical Data 19 Using the appliance - Using the oven - Hints & Tips - Using the Grill - Using the Hob 7 7 9 10 11 Installation - Positioning - Ventilation - Location 19 19 20 20 Gas connections 21 Maintenance and Cleaning 13 Conversion of gas 22 Something Not Working 15 Service & Spare Parts 16
IMPORTANT SAFETY INFORMATION You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950. Installation • This cooker must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards. • This cooker is heavy. Take care when moving it. • Any gas installation must be carried out by a registered CORGI installer.
DESCRIPTION OF THE APPLIANCE Hob 2000W semi-rapid 1000W auxiliary Cooker lid Control panel 2 3 1 4 Oven door handle Oven door with glass semi-rapid 2000W 1. 2. 3. 4.
TECHNICAL FEATURES Free standing Hob Class 1 Cooker lid Pan support Front right Back right Front left Back left Enamelled Enamelled Rapid Auxiliary Semi rapid Semi rapid Oven Oven Oven power Grill Grill power Gas 3,20kW Gas 2,50kW Accessories Oven grid Roasting tray Roasting grid Grill Deflector Height with the lid closed Height to the hob Width Depth Chromed Enamelled Chromed Enamelled 910 - 920 mm 880 - 890 mm 500 mm 600 mm Dimensions This appliance complies with the following EEC Directives : 8
USING THE APPLIANCE Before the First Use of the Cooker Remove all packaging both inside and outside of the cooker, before using it. Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal. 1. Remove the oven accessories and ensure all packaging has been removed. 2. Ignite the oven burner (see instructions) and turn the control knob to 9 (maximum). 3. Open a window for ventilation 4.
Ignition Attention: when turning on the oven and grill burner the oven door has to be opened. • • • Open the oven door and lift the small lid on the bottom of the cavity, push and turn the control knob to the left to position 9, keeping the control knob pressed. At the same time, push the electronic ignition knob (see fig). Keep it pushed until the gas ignites (1 spark / second). Release the knob after 10 seconds and check that the burner is ignited through the holes in the burner cover.
Hints and Tips Condensation and steam When food is heated it produces steam in the same way as a boiling kettle. The oven vents allow some of this steam to escape. However, always stand back from the oven when opening the oven door to allow any build up of steam or heat to release. If the steam comes into contact with a cool surface on the outside of the oven, e.g. a trim, it will condense and produce water droplets. This is quite normal and is not a fault with the oven.
Using the Grill A When using the grill it has to be supervised, the oven door opened and the grill deflector “A” in its place. Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon …) that remains tender, for toast or to brown food already cooked. Grill burner ignition Attention: when turning on the oven and grill burner the oven door has to be opened.
Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon …) that remains tender, for toast or to brown already cooked dishes. Grilling meat When using the grill it has to be supervised, the oven door opened and the grill deflector “A” in its place. Attention: when turning on the oven and grill burner the oven door has to be opened. • Prepare the meat to be grilled, lightly brush it with oil on both sides. • Place it on the roasting grid.
OR Power Cut • Push the corresponding knob in completely and turn it left to the symbol “large flame” symbol and ignite with a match. • Release the knob and watch that the burner has ignited. Upon ignition, adjust the flame as required. • If for any reason the flame should extinguish turn off the relevant control knob, leave for at least one minute and then re-ignite. Extinguishing of burners Turn the knob clockwise to mark « ». Do not put anything on the hob that is liable to melt.
MAINTENANCE AND CLEANING The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Before cleaning, ensure all control knobs are in the OFF position, and the appliance has cooled completely. Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply.
DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further. IMPORTANT: The inner door glass must be in place when using the oven.
SOMETHING NOT WORKING If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Service Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptoms Solutions 1.
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:- 08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
GUARANTEE CONDITIONS Standard Guarantee Conditions We Moffat undertake that if, within 12 months of the date of the purchase, this Moffat appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
INSTRUCTIONS FOR THE INSTALLER SAFETY ADVICE • • • • • Before installation ensure that the local distribution conditions (gas type and pressure) and the pre-setting of the appliance are consistent. This appliance must be installed only in a room with good ventilation. This appliance must not connected to a flu. It has to be installed and connected in accordance with the rules in force. Special attention should be paid to the applicable disposal concerning ventilation.
TECHNICAL DATA Table no.1 (Cat : II 2H3+) Normal power (kW) Economic power (kW) Bypass (mm) RAPID 2.60 0.72 0.42 SEMIRAPID 2.00 0.43 0.32 AUXILIARY 1.00 0.35 0.29 OVEN 3.20 1.00 0.46 GRILL 2.50 - - Burner Gas Type Natural Gas Butane Propane Natural Gas Butane Propane Natural Gas Butane Propane Natural Gas Butane Propane Natural Gas Butane Propane Pressure (mbar) Nozzle diameter (mm) 20 mbar 1.12 0,86 0,86 0.96 0,71 0,71 0.70 0,50 0,50 1.
Ventilation The room containing the cooker should have an air supply in accordance with B.S. 5440: Part 2: Current Editions. The following requirements for ventilation must be met.
GAS CONNECTIONS Your cooker is delivered adjusted for the kind of gas stated on the rating plate BACK OF THE COOKER If the appliance is supplied with natural gas and the pressure for natural gas is 20mbar.
Connection shall be by means of an appliance flexible connector for use with a self-sealing plug-in device, complying with: Flexible hoses, end fittings and sockets for gas burning appliances – BS 669; The appliance flexible connector should not be subjected to undue forces either in normal use or whilst connected or disconnected; The socket which the plug of the appliance flexible connector fits should be permanently attached to a firmly fixed gas installation pipe and positioned such that the appliance fl
Adjustment of minimum level for the hob burners The burner is correctly adjusted when the flame is stable silent and goes out without any noise. When changing the type of gas check that the minimum level is correct. The air admission is correct when the flame is about 4 mm in length. The top burners do not need adjustment of primary air. Check that, turning the knob quickly from the maximum position to the minimum one, the flame does not go out.
Oven burners The burner is correctly adjusted when the flame is stable, silent and goes out without any noise. • When the flames are too short, the nozzle is whistling or the flames have the tendency to detach from the burner, it means that there is too much air in the valve. If there is too much air there is a risk that the flames will extinguish. • But, if the flames are too long, soft, lighting, there is not enough air in the valves. These flames discolour the bottom of pans.
.
