Specifications

Gas Conversion and Specifications

Pilot Burners

1. To remove the pilot burner, disconnect the gas

supply tube from the base of the pilot burner.

2. Using a small screwdriver,withdraw injector from

inside the pilot burner.

3. Determine the correct injector size for the

corresponding gas from the rating plate attached to

the inner bulkhead adjacent to the manifold test

point behind the front control panel.

4. Fit the new pilot injector into the rear of the pilot

burner and push fully home.

5. Re-connect the gas supply tube to the base of the

pilot burner and tighten.

Piezo Igniter

Pilot Burner

Thermocouple

Fig 17

Unscrew Gas

Supply Tube Here

Thermocouple/Pilot

Burner/Igniter

Retaining Plate

Fig 16

Screw Secured

Piezo HT Lead

Gas Supply Tube

Fig 15