Specifications

Installation

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.

Assembly

Bench Models (G592 Model Only)

1. Check that all the feet are securely fitted.

Bench Models (G594 / G596 / G598 Models Only)

1. Check that all the feet are securely fitted.

2. Adjust the feet to make the Chargrill steady and level.

Mounting the Chargrill direct onto Bench / Worktop (Non-Combustible materials Only)

NOTE:

• Ensure that the bench / worktop has been suitably modified to accept the gas

connection at the rear of the chargrill.

• Ensure that the bench top surface is made of a non-combustible material.

a. Remove the grates, griddle plates and radians

from the chargrill.

b. Lower the chargrill onto it’s rear face.

c. Remove the legs and leg plates from the

underside of the chargrill.

d. Lift the chargrill back into the upright position

and place onto the bench / worktop.

e. Refit all the grates, griddle plates and radians

to the chargrill, ensuring that they are correctly

fitted.

Leg Stand Models Only

• Leg Stand Models will require assembly. Refer to the 'Fitting of Adjustable Feet /

Rollers to Leg Stand Units' information below for assembly instructions.

• The rear leg housings can be fitted with:-

a. Adjustable feet to assist with levelling of the appliance on uneven floors.

b. Rear rollers to enable the appliance to be easily moved for positioning and

cleaning purposes.

c. The front and rear leg mounting points can be removed for fitting direct onto a

bench top work surface etc without legs fitted.

Optional Accessories (Refer to Replacement Parts List)

• Plinth Kit. For installation details, refer to the instructions supplied with each kit.

Combustible Surface Non Combustible Surface

Left / Right hand side 200mm 0mm

Rear 150mm 0mm

Chargrill

Leg

Leg Plate

Fig 1