Specification Sheet

ManualsBrandsMoen ManualsBathroom AccessoriesMoen Traditional Pivoting Paper Holder

 YB1008BN– Paper Holder

Brushed Nickel Finish

 YB1008CH– Paper Holder

Chrome Finish

 YB1008BRB– Paper Holder

Mediterranean Bronze Finish

25300 AL MO E N D R IVE  NO RTH O L M STE D, OH 44070

CO R P O RATE HE A D Q U ART ER S : (800 ) 3 2 1 -88 0 9  FA X: (800) 8 48 - 6 6 36

IN T E RNAT IO NA L : (440 ) 9 6 2 -2000  FA X: ( 4 4 0 ) 962 -2726

CU ST O MER S ERV ICE (USA): 800 -882 - 0 1 16  FA X: (88 8 ) 379 -2720

WWW .MO EN .COM

Copyright Creative Specialties International Literature # BA1731

Pivoting Paper Holder post is die

cast from highest quality zinc alloy

(Zamac).

Cleaning Instructions:

1. Position the mounting template on the wall in the desired location.

2. Using a level, align the template and tape it to the wall.

3. Drill two 5/16” holes at each mounting post location that

corresponds to your product.

4. Remove the template from the wall.

5. Fold ends of the plastic toggle together and insert into each hole

in the wall.

6. Lightly tap anchors until flush with the wall.

7. One at a time, insert plastic pin into each of the anchors and

lightly tap to activate anchor. Remove pin and repeat on all

anchors.

8. Remove mounting posts from the product assemblies by

loosening each setscrew.

9. Place the mounting plate on the wall over the installed wall

anchors with “UP” facing you.

10. Insert screws through the mounting plate into the anchors. Tighten

the screws.

11. Place each assembly over the mounting posts with setscrews

facing down. Pivoting post with bar should be on the left side.

Tighten both setscrews.

Stock Number:______________________ Pivoting

Paper Holder By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Pivoting Paper Holder

YB1008

Traditional™ Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Summary of content (1 pages)

PAGE 1
Traditional™ Technical Specification Pivoting Paper Holder Stock Numbers:  YB1008BN– Paper Holder Brushed Nickel Finish  YB1008CH– Paper Holder Chrome Finish  YB1008BRB– Paper Holder Mediterranean Bronze Finish Materials: Pivoting Paper Holder post is die cast from highest quality zinc alloy (Zamac). YB1008 Dimensions: Installation Instructions: 1. Position the mounting template on the wall in the desired location. 2. Using a level, align the template and tape it to the wall. 3.