Specification Sheet

 YB1003BN – Robe Hook

Brushed Nickel Finish

 YB1003CH – Robe Hook

Chrome Finish

 YB1003BRB – Robe Hook

Mediterranean Bronze Finish

25300 AL MO E N D R IVE  NO RTH O L M STE D, OH 44070

CO R P O RATE HE A D Q U ART ER S : (800 ) 3 2 1 -88 0 9  FA X: (800) 8 48 - 6 6 36

IN T E R NAT IO NA L : (440 ) 9 6 2 - 2 0 00  FA X: ( 4 4 0 ) 962 -2726

CU ST O MER S ERV ICE (USA): 800 -882 - 0 1 16  FA X: (88 8 ) 379 -2720

WWW .MO EN .COM

Copyright Creative Specialties International Literature # BA1730

Robe Hook post is die cast from

highest quality zinc alloy (Zamac).

Cleaning Instructions:

1. Remove mounting posts from the product assemblies by

loosening each screw.

2. Position the mounting plate on the wall at desired location with

“UP” facing you. Mark hole locations.

3. Drill 2 holes as marked using 5/16” drill bit.

4. Fold ends of the plastic toggle anchor together and insert into

each hole in the wall.

5. Lightly tap anchors until flush with the wall.

6. One at a time, insert plastic pin into each anchor and lightly tap to

activate anchor. Remove pin and repeat on the other anchor.

7. Place the mounting plate on the wall over the install wall anchors

with “UP” facing you.

8. Tighten screws.

9. Place decorative product over the mounting plate with the

setscrew facing down. Tighten setscrew.

Stock Number:______________________ Robe Hook

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Robe Hook

YB1003

Traditional™ Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

PAGE 1
Traditional™ Technical Specification Robe Hook Stock Numbers:  YB1003BN – Robe Hook Brushed Nickel Finish  YB1003CH – Robe Hook Chrome Finish  YB1003BRB – Robe Hook Mediterranean Bronze Finish Materials: Robe Hook post is die cast from highest quality zinc alloy (Zamac). YB1003 Dimensions: Installation Instructions: 1. Remove mounting posts from the product assemblies by loosening each screw. 2. Position the mounting plate on the wall at desired location with “UP” facing you. Mark hole locations.