Dimensions Guide

Arris
™
Accessories Technical Specication
Paper Holder YB0808
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0808CH – Paper Holder
Chrome Finish
YB0808BN – Paper Holder
Brushed Nickel Finish
YB0808BL – Paper Holder
Matte Black Finish
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 1/4" holes at each mounting post location that corresponds to your
product.
4. Remove the template from the wall.
5. Disassemble screws and washers from anchors.
6. Lightly tap anchors until ush with the wall.
7. Remove mounting posts from the product assemblies by loosening each
setscrew.
8. One at a time, place each mounting plate over anchors (with "UP" facing you)
and insert screw and washer through plate into anchor.
9. Tighten screws until anchor is activated behind wall (approximately 45 turns)
and tight.
10. Place each assembly over the mounting posts with setscrews facing down.
Pivoting post with bar should be on the left side. Tighten both setscrews.
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.
Paper Holder
is constructed of zinc.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen Incorporated
Stock Number: _________________________ Paper Holder
By Moen Incorporated
25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809  FAX: [phone]
INTERNATIONAL: (440) 962- 2000  FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882- 0116  FAX: [phone]
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1718
Paper Holder is constructed of zinc.
 YB0808BN – Pivoting Paper Holder
Brushed Nickel Finish
 YB0808CH – Pivoting Paper Holder
Chrome Finish
Cleaning Instructions:
1) Position the mounting template on the wall in the desired location.
2) Using a level, align the template and tape it to the wall.
3) Drill two ¼” holes at each mounting post location that corresponds to
your product.
4) Remove the template from the wall.
5) Disassemble screws and washers from anchors.
6) Lightly tap anchors until flush with the wall.
7) Remove mounting posts from the product assemblies by loosening
each setscrew.
8) One at a time, place each mounting plate over anchors (with “UP”
facing you) and insert screw and washer through plate into anchor.
9) Tighten screws until anchor is activated behind wall (approximately 45
turns) and tight.
10) Place each assembly over the mounting posts with setscrews facing
down. Pivoting post with bar should be on the left side. Tighten both
setscrews.
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
YB0808
Arris
TM
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.