Specification Sheet

Colinet™ Accessories Technical Specication
Towel Ring YB0586
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0586CH – Towel Ring
Chrome Finish
YB0586BN – Towel Ring
Brushed Nickel Finish
YB0586BG – Towel Ring
Brushed Gold Finish
YB0586BL – Towel Ring
Matte Black Finish
1. Position the assembled unit on the wall where desired.
2. Using a level, align the provided template and tape it to the wall.
3. Mark the desired hole locations through the template (such as tracing or
poking holes).
4. Remove the mounting bracket from the body by loosening the setscrew.
5. Center mounting bracket within the base outline with “UP” facing you.
6. Attach the mounting bracket to the wall, using the wall anchors provided.
7. Mount the base on the corresponding mounting bracket. Check and make sure
that the base screw hole is facing down. Assemble a set screw to the base. Use
the
hex wrench included in a hardware kit to tighten the set screw and secure
the assembly to the mounting bracket.
If you are mounting any parts into a hard surface snap o the anti-rotation ns on the
back of the mounting post.
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry well.
Do not use commercial or abrasive cleaners.
Towel Ring is constructed of zinc and ceramic
post with solid brass ring.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©2020
Copyright Moen Incorporated
Stock Number: ___________________________ Towel Ring
By Moen Incorporated
1-15/16"
25mm
7-1/2"
178mm
5-3/4"
127mm
3-5/8"
76mm
2"
51mm